We have a good-sized garden, and as any (deluded) home farmer, we decided we’d grow food. We had the occasional tomato and lettuce out of it, but low-to the ground garden beds proved to be a lot of effort for a rather disappointing yield. A large part of the effort was in the perpetual need to weed out anything whose seed landed into the bed, and, adding insult to injury, having to bend down low to the ground for the privilege.
Another problem was with the watering of those precious crops during the dryer months. I already have a ram pump to lift water from the nearby creek to the top of the garden, but distributing the water was left as an exercise to the reader. Spray watering uses a lot of undirected water, and dries out to evaporation quickly. Drip watering only keeps small areas moist. What do?
In a quest for a better garden bed, we happened upon the concept of wicking beds. They are higher-from-the ground garden beds, with lower substrate able to hold a lot of water. On top of this, normal gardening soil allows to grow the prized veggies. The name comes from the mechanism that pulls the water from the lower level into the top soil, keeping the plants nice and hydrated.
It was time to build some. Connecting the overflow from the ram pump was plenty enough to keep them well watered (even too much in winter). The higher clearance from the ground also led to a massively diminished weed problem, and not having to bend down to remove the few stragglers. To top it off, I added little cupolas made of polypipe with insect netting on top, to keep the crops all for ourselves. As for the yield? Well, we had a few leeks. At least two or three. No lying!
tl;dr: We used
- pre-fab ~1m3 bed kits and a pond liner for the structure,
- an ag-pipe and some sand for the lower tier,
- geotextile as a barrier before putting the garden soil and mulch on top,
- plumbing bits and bobs to control intake, but also drainage as needed, and
- polypipe and insect protection, which is optional, but useful.
Continue reading →